Description
32mm MDPE 90° Elbow – Compression
This 32mm MDPE 90° Elbow is used to change the direction of 32mm MDPE blue or black water pipe by 90 degrees. Both ends use compression joints with internal stainless steel grip rings and rubber EPDM O-ring seals. No inserts needed – cut the pipe square, chamfer the edge, push each pipe into the fitting until it hits the stop, then tighten the nut hand-tight plus 1 to 1.5 turns with a spanner. The grip rings lock the pipe in place and the O-rings create watertight seals rated to 16 bar. Used for routing 32mm property mains around corners, entering buildings through ducts, dropping into meter boxes, and navigating trenches. 32mm is the standard UK size for domestic mains connections. Suitable for use with MDPE pipe to BS 6572 and BS EN 12201. WRAS approved for use with potable drinking water. UV stabilised polypropylene body resists frost and ground conditions. Not suitable for gas or hot water above 20°C. Reusable if undamaged – loosen the nuts and pull the pipes out. Full-bore design maintains flow with minimal pressure drop.
